4 speed hump location measurements

Discussion in 'Body Restoration' started by BTTB71SS, Feb 3, 2010.

  1. BTTB71SS

    BTTB71SS Veteran Member Lifetime Gold Member

    5,476
    0
    May 10, 2006
    Harris, MN
    Ok got a 4 spd hump from a member (Chris - thanks again) and now i want to weld it in.

    The question i have is I need the measurements from all 4 sides to properly place it over the hole in the tunnel.

    Any help would be great.

    Thanks,
    Rick
     
  2. Twisted_Metal

    Twisted_Metal Moderator Lifetime Gold Member

    24,233
    36
    Feb 26, 2004
    Bloomington, MN
    Psssst, Rick........ I think your 78 has a factory 4-speed hump in it.
    It's out there in your garage. ;)
     
  3. BTTB71SS

    BTTB71SS Veteran Member Lifetime Gold Member

    5,476
    0
    May 10, 2006
    Harris, MN
    Terry....Pssssst.... Not anymore... Its in the backyard under a tarp covered in snow and on Jack stands...:whine:

    Upper garage now holds friends 81z, 280zx and the 71ss which i can't get to either ;)
     
  4. 76_TypeLT

    76_TypeLT Veteran Member Lifetime Gold Member

    5,760
    19
    Jul 26, 2008
    Houston, TX
    Curious question - if your Camaro has factory auto tranny and you want to install a manual tranny but you don't want the manual console, do you need to have the 4-speed hump to have the factory look or is that only needed when you actually install a manual console??

    Sorry for the hijack :eek:
     
  5. BTTB71SS

    BTTB71SS Veteran Member Lifetime Gold Member

    5,476
    0
    May 10, 2006
    Harris, MN

    You still need the hump even if you don't run a console i believe. The 71ss I have in the upper garage is console delete but still has the hump.

    Hope that helps
     
  6. olstyle

    olstyle Veteran Member Lifetime Gold Member

    8,724
    0
    Jan 27, 2008
    Crestwood IL.
    Ya need the hump with or without a console. Without a console the boots screws to it.
     
  7. Twisted_Metal

    Twisted_Metal Moderator Lifetime Gold Member

    24,233
    36
    Feb 26, 2004
    Bloomington, MN

    Don't ya hate that?

    I ordered some new interior hardware because I couldn't chop the ice away from my storage shed to retrieve the parts I already own.
    (Due to poor planning last fall..... All my ice removal tools are INSIDE the shed. :mad: )
     
  8. EricsZ28

    EricsZ28 Veteran Member Lifetime Gold Member

    3,487
    0
    Feb 28, 2006
    Here and there...
  9. BTTB71SS

    BTTB71SS Veteran Member Lifetime Gold Member

    5,476
    0
    May 10, 2006
    Harris, MN

    Eric Thanks... That gives me a rough estimate... I have no door panels on the doors so will have to compensate for that..
     
  10. BTTB71SS

    BTTB71SS Veteran Member Lifetime Gold Member

    5,476
    0
    May 10, 2006
    Harris, MN

    LMAO... Yep that is great planning there Terry;)
     

Share This Page