Electronic Throttle for Gen2

Discussion in 'High Tech Retrofits' started by mrvedit, Jul 23, 2019.

  1. mrvedit

    mrvedit Veteran Member

    Messages:
    1,355
    Likes Received:
    4
    Joined:
    Jun 12, 2009
    Location:
    Ann Arbor, MI
    IGNORE - I just found this thread:
    http://nastyz28.com/threads/connect-and-cruise-throttle-pedal-bracket-for-ls-swap.325255/

    I'm switching from "Drive by Cable" to "Drive by Wire" on my LS3 engine because I am upgrading to a dual throttle body intake manifold. (Testing both the Edelbrock and Holley manifolds.)
    Unfortunately the position and angle of a GM Electronic Pedal assembly is nowhere close to the Gen 2 firewall.
    I recall reading 5+ years ago that a member here had manufactured and was selling an adapter to bolt the Electronic Pedal into a Gen 2.
    Does anyone know more about this or perhaps have other commercial solutions.
    Thanks.
     
    Last edited: Jul 23, 2019
  2. CorkyE

    CorkyE Veteran Member Lifetime Gold Member

    Messages:
    10,110
    Likes Received:
    384
    Joined:
    Nov 4, 2004
    Location:
    Ringgold, GA
    Lol - I just copied that link, getting ready to paste. Good luck with the project.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.