Thermostat Housing

Discussion in 'Engine Topic' started by 76z28, Jun 8, 2019.

  1. 76z28

    76z28 Veteran Member

    Messages:
    1,970
    Likes Received:
    40
    Joined:
    Jun 29, 2009
    Location:
    bakersfield
    Does anyone know if an LT1(90s era) thermostat housing will fit on a traditional small block/big block?

    If so, that would enable me to use an "LS" radiator which would put both hoses going to the same side. In this case, that would allow me to run my intake to the driver side and try to get cooler air into it. I currently have AIT of about 150* which I know is killing power.

    For reference:
    https://www.ebay.com/itm/CORVETTE-C...m23975ac840:g:kPEAAOSwPRxZdbA5&frcectupt=true
     
  2. 76z28

    76z28 Veteran Member

    Messages:
    1,970
    Likes Received:
    40
    Joined:
    Jun 29, 2009
    Location:
    bakersfield

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.