Separate names with a comma.
I've removed the heater control from the car, and would like to detail it, would you guys paint the sliders? or do you think the paint will come...
If you have a welder, you can buy a steel "tee" 3/8" 3/8" 1/4", and weld the 1/4" port and then drill it out with a #67 brill bit which will give...
If you don't want to change the pump, you can add a T on the pressure side of the pump to carb line, Add an orifice with a 0.030" orifice and...
Would a Pontiac 400/455 Trans Am factory 4 core radiator fit? anyone tried?...
Here is my '81, factory paint #77 Maroon [ATTACH]
No, that was drilled for rust proofing
I had a look at that, I already have the SPI primer and activator would hate for it to go bad
I have everything welded in. My next step is apply SPI Epoxy primer, Since I do not have my big compressor & air lines plumbed I can not use a...
Trans am did come with 2.73:1 and so did some camaro’s the only way to know for sure is to remove the cover and count the teeth or read the number...
The more that I think about but your right, I went ahead and ordered both stainless steel lines, my factory lines had better days if I cut the...
this is just a regular TH350 , no lock up converter
I'm going to be installing an external transmission cooler along using the rad cooler, I'm planning running two -6 PTFE braided lines, I would...
the threads are 1/4-20 [ATTACH] [ATTACH] [ATTACH] [ATTACH]
