Separate names with a comma.
Quite sure it's the same as my '70. It's a fibre optic wire that is attached to one of the dash bulb sockets, and fits into a small plastic...
Greg, I notice that you don't have the bracket bolted to the back of the alternator that is supported by the spacer bolt ( see Dave's pic of it)....
For reference, that bottom spacer is 2 7/8" long.
Is that a short leg pump of some sort? Maybe it's just the picture, but it doesn't look like enough space between the back of the pump & the front...
I think once you remove the four screws, you can hold it up enough to remove the centre piece from the rest of the plate. Can't remember if it has...
This is what your shifter plate should look like, except having wood grain where this one is black. If you don't have this, you must not have a...
Did someone put some fake wood over the shift plate & cover up the screws? There should be a screw in each corner of the plate. I've never...
I think now that they are different. The one I'm talking about is straight, not bent, 1/2" wide, 1" long. The original pic looked more like it...
That actually looks like #3784832 clip. Bolts to the last hole at rear of head on big block, in line with exhaust manifold, holds the oil pressure...
That mirror foot in the pic of Jacks car is glued to the windshield upside down. You can see the smudge of glue where it was reattached by someone.
04D
Many years ago the two piece stem on my mirror cracked. In the meantime, before I found a good one, I repaired the broken one with a splint made...
Testor makes a fluorescent orange that is spot on to the '79-'81 Camaro gauge needles. Should be able to get it at any hobby shop.
Also, if you look in the 1970 "F" body manual, it shows no washer on the rear belt mounts.
Since my last post (2010), I did take the rear seat out to look. My car does not have that washer on the rear belts. As you all know, I am the...