70lt1z28's Recent Activity

  1. 70lt1z28 replied to the thread 302 aluminum intake?.

    I would look into vapor blasting aka vapor honing. Really deep cleans the aluminum without messing with the surface texture....

    Dec 7, 2021 at 6:42 AM
  2. 70lt1z28 posted a new thread.

    Some MCACN THNDER

    Just ran across this on Youtube. Congrats Mike. Your car is really cool. [MEDIA] Why does Lou Costable check EVERYBODY's brake...

    Forum: The BS Topic

    Dec 6, 2021 at 3:10 PM
  3. 70lt1z28 replied to the thread Welding Sheet Metal Help.

    Fill the holes for sure.

    Dec 5, 2021 at 8:04 PM
  4. 70lt1z28 liked badazz81z28's post in the thread Welding Sheet Metal Help.

    No going back! It’s cut! [ATTACH] [ATTACH] [ATTACH]

    43C4C5EB-6764-4316-B4C4-1061F63D2264.jpeg 0C7D09B6-CA2E-4A03-9E52-FB1D37F242C3.jpeg 1740BEC3-7A97-4975-8E19-D2307D82B1ED.jpeg Dec 5, 2021 at 7:03 PM
  5. 70lt1z28 attached a file to the thread 1970 tcs relay.

    The solenoid is connected to the trans switch but there is a relay also in the loop. The relay is riveted on to the plastic wiring...

    upload_2021-12-5_16-1-16.png Dec 5, 2021 at 3:50 PM
  6. 70lt1z28 replied to the thread 1970 tcs relay.

    Not for gage or lights at all. The gage or light sending unit is in the drivers side head. The passenger head sending unit is only for...

    Dec 5, 2021 at 2:09 PM
  7. 70lt1z28 replied to the thread Welding Sheet Metal Help.

    The way I would approach it is to measure the current cutout on the original fender and add about a half inch to each edge. An easy way...

    Dec 3, 2021 at 8:48 PM
  8. 70lt1z28 replied to the thread Passenger Head TCS Sending Unit Availability?.

    Most folks add a tee fitting at the oil pressure sending unit. If you want to keep it looking stock there, there is a plugged outlet...

    Dec 3, 2021 at 11:15 AM
  9. 70lt1z28 replied to the thread Fake emails.

    Besides setting up a whitelist which is a real PIA to maintain, not much you can do. I've set my phone to only ring on folks in my...

    Dec 2, 2021 at 2:09 PM
  10. 70lt1z28 replied to the thread 1970-74 75? Outside door handle disassembly-restore.

    Thought about it and if I was retired I might do a few, basically just for something to do. To much going on now in my life that I'm...

    Dec 2, 2021 at 8:38 AM
  11. 70lt1z28 replied to the thread Welding Sheet Metal Help.

    I don't see where in this case a bigger cut will help anything. There aren't any natural lines to cut to anywhere close. Hard to tell,...

    Dec 1, 2021
  12. 70lt1z28 replied to the thread 70 LT1 FT Camshaft Options.

    Not sure if this site is still good (I think it is) but it says all of Canada Shell V-power and Canadian Tire 91 is ethanol free:...

    Dec 1, 2021