Separate names with a comma.
If If you don't do a lot of extended highway driving at higher speeds, go with the 342. If a lot of 70 mile per hour highway runs are in your...
I did the exact same combo on my 68 Chevelle. I originally ran with factory master cylinder in booster But braking performance was terrible. I...
Making good progress i almost bought a red/orange car with black interior over the summer but I really wanted a 4 spd.
My 81 Z has a large vertical dent/crease that the body shop says is cost prohibitve to repair. Looking for a GM skin.
No first gen cars.
I found this place a few weeks ago and wanted to pass along. I bought various parts for my '81 Z28 (console, shifter, door, header panel, bumper...
A member out here posted somewhere that the PTFB guy said 18 x 9.5s with 5.25 BS will fit the front and long as you run the PTFB sway bar and...
I ended up ordering a Jegs 6qt pan made in the USA. It will be a while before I get the engine in the car, so no feedback other than it looks...
The block is a 1972 two piece rms. Thanks though.
Building a 383 for my '81 and found this old thread from 2009: https://nastyz28.com/threads/sbc-355ci-oil-pan-suggestions.179005/ Car will be...
Looking for a rust free driver side door for my 81Z. I'd prefer a door with the crash brace that the 81 came with. My current door has a large...
