Separate names with a comma.
It holds the wire loom to the back of the engine not the trans dipstick.
What section should I post this in?
I am looking for this ... it is connected to the wire loom at the firewall and anchors around the engine.
Thank you both!
Thought this was going to be a PIA even with the engine out of the car but it wasn't bad at all. Here are the old mounts:
Okay today I got out at 3pm, loaded my engine into the pickup drove over to SK Speed they took the engine off the back of the truck; Jeff and...
Okay engine is out of the car ... I hope the engine builder can fix it ... I do have the broken piece and it lines up perfectly.
I have a TKO500 and a 409 with about 550+HP and love to race and drive like I stole it. When you get a 5spd you are going to change your life...
I think so but can't remember it was built in '09.
I spoke to my engine builder he said it's not as bad as it looks. He said GM built the boss like that and the material there like that as this...
Might be my only option. Not sure what to do because it is a 600hp engine.
Worst possible outcome ... I got half of it out ... and the casting broke super easy. I have a feeling this is why my leak was never found.
Much better ... No. 4 is a little week but within tolerance to 2.