Separate names with a comma.
I dont know which shop did the work on the seats and door panels, they were like that when i purchased the car.
SOLD Car on 12/24/20
5th digit is a K
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Your looking at a 73 Camaro that had a...
Russ is correct i removed the package tray area and still a no go. To install in one piece the tail panel must come off. I wound up cutting the...
Bow, the car and cherry picker were braced before any work was done on the bottom.
Heres another pile of rust. At this point there was no turning back. [IMG] [IMG] After all metal work was done the car was stripped to...
Sorry pan is installed with fuel tank in place, cant get to the braces for a measurement.
Sorry I dont have any measurements for the braces but I have a few pics that might help you. [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
AMD hood, fit is good except where the cowl meets the windshield. Not enough clearance to run wipers. [IMG] [IMG] [IMG] [IMG]
That is a full trunk panel with braces. All of my rust was inside of the frame rails. So I trimmed it to have the weld seam fall on top of the...
The only way to fit your trunk pan in one piece is to remove the tail panel. Or you can cut it in two and weld it back together once inside....
A little bit of fiberglass mat will fix that right up. I had similar damage on my cover. [IMG] [IMG] A few mixing sticks were cut and glued...
Thanks Guys.. glad to be back.
