Recent content by Edem_Alive

  1. Edem_Alive

    Selling an older truck, what would you do?

    Thats easily a 5k truck with only 60k miles
  2. Edem_Alive

    Spraying Primer - single stage or 2 stage air compressor

    I also have a quincy with about 30 feet of copper tubing and get a little water after about an hour. It is much better than w/o. I can drain the water from the pipes and the compressor and go for another hour pretty easily. These comps are awesome!
  3. Edem_Alive

    Roof Panel

    Hmmm I do need that. Wonder if I could do a freight call tag.
  4. Edem_Alive

    Question about harassment or threats

    Call the poilice and file a report so you have a paper trail documenting this in case anything ever does happen. Then, if it does, everything will go your way no problem. File a report and forget about it.
  5. Edem_Alive

    540 Big Block 81 Camaro build

    buy another hood!
  6. Edem_Alive

    Trust

    Cashiers check or Money order only
  7. Edem_Alive

    New Shop!

    I find myself wanting 10' ceilings
  8. Edem_Alive

    Helicoil advice on crank snout - I'm a thread too long

    Sounds like a good plan. I'll try it out. Thanks!
  9. Edem_Alive

    Helicoil advice on crank snout - I'm a thread too long

    I had already broken the tang unfortunately. It also has red loctite and sat overnight this way so not sure how easily it would come out.
  10. Edem_Alive

    CRAP! stripped bolt hole in cyl head for intake manifold bolts

    As long as its also round with no taper it can be held in a 3 jaw drill chuck.
  11. Edem_Alive

    New Shop!

    I think you'll regret having your mother in law in there xD
  12. Edem_Alive

    Helicoil advice on crank snout - I'm a thread too long

    The problem is that I cannot screw in the screw because the helicoil spring pressure is holding it out like that. So I can't get the threads started. Should I try loctite and clamping it into the bottom for a while?
  13. Edem_Alive

    Helicoil advice on crank snout - I'm a thread too long

    Hey guys, I drilled, tapped, and installed two helicoils but as you can see the last one is just about 1 rotation too long. Should I attempt to snap it sideways or grind it or..?




Latest posts

Top