Recent content by Pete77LT

  1. P

    Budget Dual Fan Controller Setup / Taurus Fan Setup

    Thanks for the reply. I was thinking I could use one post on the switch to trigger one relay and fan, and the other post to trigger the other. Just wasnt sure if the low side would switch off when the high side kicked on, turning off one fan.
  2. P

    Budget Dual Fan Controller Setup / Taurus Fan Setup

    So I read that this set up wont work with dual fans, ie LS1, correct? Now my question is that will this BMW temp switch work to power two separate relays? Have one fan turn on at low temp and boths fans running at the higher temp? Thanks
  3. P

    Feb 13 North OC cruise

    Ouch that sucks, I won't be able to make it after all, turns out I have to work sunday.
  4. P

    Feb 13 North OC cruise

    I'm off of Gale and Stimson, that is really close. I painted the car myself, I worked with my dad at a body shop painting cars for about 10 years.
  5. P

    Feb 13 North OC cruise

    Looks like we're gonna make it after all! I'm pretty excited, haven't driven the camaro this far in awhile.
  6. P

    Feb 13 North OC cruise

    I would, but I'm supposed to go to Santa Barbara that weekend with the gf for Vday. If I get get back in the area in time, I will definately join you guys.
  7. P

    Feb 13 North OC cruise

    Turnbull Canyon is right by my house. Its a fun drive!
  8. P

    Guys project 74 Z28

    I've always used 2000 on panels that are getting only clear. As for the sealer, it'll leave a rough edge if you just try to spot it, unless its a sanding sealer, then you can smooth the edge out, but I've only used sealer on entire panels. 400 will be good for the repair spot, just go over it...
  9. P

    Guys project 74 Z28

    Dang, that really sux. If I could give you a few tips though. I wouldn't seal it, just block the primer and spray right over it. Hopefully there isn't a next time but if there is, try not to leave those sharp edges with the primer. Sometimes it can be tough to block the edges down. Then just...
  10. P

    Burnout pics... Show yours..

    Heres my weine one, before the posi and gear change. Notice my oops at the beginning :screwup:
  11. P

    Stainless Steel Headers

    /\/\/\/\ Those are the ones I have. They fit well, altough I had to switch to the "short" spark plugs. I also cut the flanges so the tubes would seal up independently. I installed these about 3 years ago and suprisingly, the finish has held up quite nicely. Only bad part is underneath the...
  12. P

    how hard is a heater core replacement job?

    Nope, used an AC heater core. The non AC pipes exit on the other side.
  13. P

    how hard is a heater core replacement job?

    It wasn't that bad, although I did remove the entire fender as well. Just about a billion screws and crap to remove. I had AC, but I replaced the outer cover with an AC delete cover from American Graffiti. I still have my heat and defrost and I'm glad I kept it. If you go that route, try to...
  14. P

    81 master cyliner

    Good to know, not in the market for a new booster though. Thanks for the info.




Top