thesalboy's Recent Activity

  1. thesalboy replied to the thread 75 Bumblebee LT4 Gen V swap.

    Found and zoomed in on original. I beat everything flat and filled with seam sealer before epoxy/Raptor. [IMG]

    Sep 20, 2020 at 5:40 PM
  2. thesalboy replied to the thread 75 Bumblebee LT4 Gen V swap.

    Nothing closer than this. I did many relief cuts. [IMG]

    Sep 20, 2020 at 5:26 PM
  3. thesalboy replied to the thread 75 Bumblebee LT4 Gen V swap.

    I pie cut, folded, and welded my rear wheel opening, and with three layers welded together, it's plenty sturdy. Has metal been...

    Sep 20, 2020 at 2:41 PM
  4. thesalboy replied to the thread ?? differences in frames rear seat buns.

    70 only tho right?

    Sep 17, 2020 at 8:52 PM
  5. thesalboy replied to the thread Camaro RS LS1 Build Thread.

    Stumbled across a pic of the lock cylinder in Fisher that included that clip - it is the OE clip for mounting the pawl to the cylinder....

    Sep 17, 2020 at 6:57 PM
  6. thesalboy replied to the thread ?? differences in frames rear seat buns.

    I confirm that OER SF 139 is very thick, and seat covers must be super stretched to install them. You could cut the foam, but only from...

    Sep 17, 2020 at 6:42 PM
  7. thesalboy replied to the thread Camaro RS LS1 Build Thread.

    I need to up the fan trigger temps when I get it tuned - low circuit is 180, so they will otherwise be on all the time. It's a higher...

    Sep 17, 2020 at 6:34 PM
  8. thesalboy replied to the thread Camaro RS LS1 Build Thread.

    I was hesitant to tackle installing my TMI matching rear seat upholstery until I started checking installer prices and wait time. I...

    Sep 17, 2020 at 6:14 PM
  9. thesalboy replied to the thread Camaro RS LS1 Build Thread.

    To be clear, my understanding is that you cannot get a 600 series steering box that isn't at best potentially crap, no matter where you...

    Sep 17, 2020 at 4:50 PM
  10. thesalboy replied to the thread Camaro RS LS1 Build Thread.

    The guy at Lee referenced those. I'm gathering that they (including AGR) are all from the same ODM in China. Yeah it's just that the...

    Sep 17, 2020 at 1:36 PM
  11. thesalboy replied to the thread Camaro RS LS1 Build Thread.

    Update on my PSC steering box: IT'S JUNK! I finally test drove the car and the steering is TERRIBLE - sloppy, vague, no on-center,...

    Sep 16, 2020 at 2:10 PM