Separate names with a comma.
Fired it up today for the first time in a month or so. Hoping to get a bit of use out of it over Christmas if we get a couple of dry days :) [MEDIA]
You have that the wrong way around... A smaller bore mc will give a longer pedal, but higher line pressure. I will check the parking brake cable...
The M/C is a dual 1.125" one, which I am sure should work fine with a disc/disc set up. I have a manual bias valve in the rear line, so it's...
I'm working on a friend's 79 Camaro and having issues with the brakes. Under heavy braking the light comes on on the dash. Then goes off when the...
Thanks. They were Dougs adapter mounts with the 1" set back position, which actually puts the rear of the block in the same place as the...
Budget 28" wide one and made up some hoses. Single 14" mounted behind, no shroud, fits and cools great [IMG]
Swapped out my intake today. Removed the sheet metal one in favour of an Edelbrock Victor Jr with a 1200cfm throttle body on top of it. Doesn't...
I have 4.11s but a 4L80E and my highway rpm's are around 3000 at 70mph. Would be a little lower with a 4L60. Plus with the 4l60 you get the...
Went for a short drive today - seems to be far better than it was. Very minor whine on deceleration. But it probably doesn't help my axle is solid...
Thanks. Hopefully the pre-load is OK. When I stripped it down there was virtually no pinion pre-load and I just lifted the carrier out by hand....
I haven't done anything on this for a while, been using it, mostly racing! But the rear axle was getting noisier and noisier and making some...
Oh, and as promised [IMG]
Anyone comment on my gear pattern before I button it all up? [IMG] [IMG]
Inlet is the 3/4" connection and outlet is the 5/8"
Thanks, I'll double check it before install. Just waiting on a Yukon solid pinion spacer/shim kit, then I'll be getting on with it :D
The Koyo bearings in the kit clearly say Koyo USA on them - all extra load rated. Will grab photos when I get a minute.
I'll see how I get on and report back the results... What's the best backlash to aim for? 0.010"?
Hmm why not? It's got all USA made bearings - Koyo in this one. I've not done an axle before... will give it a go under the car and see how I...
My 12 bolt whines and groans pretty badly now, so it's time for a rebuild. The parts arrived from Summit, sticking with the same ratio as...
I'll give it a go... Next time out is 4th September - back on a fully prepared track too