Separate names with a comma.
I personally would leave it as is, the pattern is not running off the edge of the tooth.
I don't know of any heads with a heat crossover that would require a gasket with that large of a port. 2.21 x 1.31 is much larger than a stock head.
What heads are ya using?
It will be fine, It's just a spacer.
I would try 91 octane and see. It will make more power on 91 if it doesn't detonate.
I never touch the oil pan screws. I'll pull on the front cover until it pops out. I will clean everything with brake clean. I'll then clip the...
Here is my camshaft pick for those poor heads.
I used 1 of these 30 years...
Has anyone seen the ball snap off a push rod with the welded balls? I'm sure it has happened, I've never seen it personally.
Here is a copy and paste from thread #29 (putting a Chevy engine in a 67 mustang) at mustangforums.com
the swap will require you to...
Hey Seth, what are you doing with the motor from the mustang? I've got a Camaro I'd like to put it in.
I was looking at some LT4 heads yesterday, They are awesome. They make the LS stuff look like 20 year old technology.
I use stainless allen head screws on intakes often. I have a short piece of 5/16 allen that is 3/4" long. I use a 5/16 gear-wrench for the center...
That poor cat, just got skinned again. That's 5 minutes of my live I'm not getting back.
Sandlapper nailed it. I'd use the same. look them up on rock auto.
I went to a piston ring seminar here in Calgary in the 80"s sometime. It was put on by sealed power. They told us not to de-glaze when re-ringing...
Crower sells stud mounted rockers with as much as 1.85 ratio.
I'll never do it that way either. With hydraulic lifers on the stand, I would get it done at-least 50% faster than his method. I would bring...