Separate names with a comma.
I picked up a pair of big block springs, supposed to be Guldstrand, what kind of drop do they have? I have 2 inch drop leafs for the rear
I have a pair, PM if still looking
thanks guys. Keith, it wasn't the accelerator plunger actuator, which does look similar, Ron was correct it was the plug he described. but if this...
Check the linkage from the steering column if its worn or loose it may be the problem.
I recently purchased a 1981 Corvette in need of some work. Car had been sitting for some time, so I drained the dead gas and sludge from the tank,...
I have a pair of rear leafs holding the shell of my 73 up. never been on the street. putting steel springs in it this spring. PM me if interested
sorry for your loss... Looks like the old Goodmark project Camaro, beautiful car.
I have a low mileage crate 350 short block. heads are long gone, but I have a pair of 88 corvette aluminum heads ('113 castings) which are 58 cc...
for aluminum you should use an etching primer followed by the paint. do not use epoxy over the etch primer, it will peel off in short order....
lol, Great deal! I did a little better though- my "fresh 25 year old" 454 never had oil in it, but I have Hypereutectic LS6 pistons! and paid...
I have one. where are you?
or you might try Fbodywarehouse
they are scared of a little surface rust I guess. maybe I should trim the outer sheetmetal and blast and epoxy prime them too.
You need the correct speedometer gear. I don't remember which one it is, but they are plastic and color coded. They are not difficult to change...
Bump. Still have them
paint them before you undercoat. epoxy primer will seal, but etch does not. etch prime is great stuff, but like regular primer is a sponge, and...
bump
PM me your number, I will take a picture and send it to you. I have the floor section cut out with braces and rockers intact
Sold and on the way, Thank you Patrick!
