Separate names with a comma.
Most people wouldn't consider spinning the tires to be a drawback. That just means you need to improve how you put the torque to the pavement.
Are you looking for clearance or flow? I ran a set of regular Hooker 1 5/8 tubes for about 5 years before the bottom of the collector rotted out....
If your friend thinks the timing is set properly then it's time to buy your own timing light. I hear a lot of people say whatever they want about...
If you want a lightweight hood unfortunately you're pretty limited to unlimited products. They're fiberglass and they don't have the best...
Carbon fiber is nice but will it bolt on? Probably not. There's 500 in time and labor unless you do it yourself. My buddy bought a brand new...
You guys would laugh at the kind of loads we lift at my work with a hook that's mounted to the ceiling and held in place by bolts.
I'll tell you a bit of a story. I ordered an AMD trunk lid. Right out of the box I could tell the corner was bent at a 90 degree angle like...
Hey, it could be worse. There could be no new sheet metal available. Yeah I complained about my replacement sheet metal on the camaro but I did...
Strip it with 80 grit on a DA. You're not going to find good paint stripper these days. A few years ago they took the methylene chloride out and...
Dude like 351 Maverick said, JB weld it and be done. The intake doesn't get hot enough to melt epoxy nor should it ever reach those temperatures....
Your ignition timing I probably off. Try plugging the vacuum advance (if you have it) and setting the total timing at 32-36 degrees.
I reused the best ones I had and deleted one with a patch I made to repair the toe board area. They aren't necessary unless you're planning to...
Forgot to include that her husband was a gunner in one of those old glass bubbles on the wing of a bomber. Man had balls of steel.
I went and minored in anthropology for some inexplicable reason. I know what they're going to find. Skeletons and the stuff you see on...
Any of you guys like this? [MEDIA]
In my old school Ford rebuilding book (yes I know... Ford...) there's a picture of a cylinder boring tool that bolts directly to the deck surface...
I've successfully revved a stock bottom end 350 with stock valve springs to 7500 rpms with no problem. What makes the LS lifters better?...
I like to use Corroseal
So I looked up the l82 cam specs. You're right Lowend as far as duration and lift but the l82 is on a 114 not a 106 lsa.
This is all very true. 882 heads though are not necessarily bad. They will make over 350 hp. As far as flow numbers go they're decent for a...
