Separate names with a comma.
The AFR will never be a perfect flat number espescially with a carburetor. Say you floor the car from 10 mph you should be lean 14s then at wot...
I use a AEM 30-0300x with hptuners. As far as a device to log data with a carb you won’t really have anything to compare AFR to vs anything. With...
Do you have the part number for that by any chance? All I can find is just the rubber.
15 years ago or so (I was 13-14) I changed the rag joint on my 80 Trans Am. I was a kid and didn’t remove the shaft or see the purpose of the...
Yes. Will the stock 4th gen Camaro clutch line reach.
Take a small camping torch and heat the nut up then use 2 vice grips.
Just curious did the stock 4th gen clutch line reach or will I need a different one?
Got the new axles in. Rotor goes right on.
I plan to paint my firewall base coat/clear with the black the car will be but I want the wiper cowl and inner dash a more semi gloss like the...
Moser is sending two axles.
Yea studs were definitely straight. I haven’t measured the knurl I called moser and asked for studs and they gave me their part number and ordered...
New rotors still won’t work. Here’s pictures of a stock axle pattern and the new axle.
[ATTACH] [ATTACH]
The axles are suppose to be direct fit just in 30 spline. I used a 30 spline carrier when I put the rearend together. I had problems with the...
I’ve got 2 sets of rotors I’ve taken from my 2000 and 2002 trans am that I just had laying around. I’m 99.9 percent sure they’re the rotors I took...
That’s the rear brakes and rear rotor from a 2000 z28. The axle is a 103003-a moser. Suppose to be a direct fit 30 spline for my 80.
So what’s the fix for this drill the rotor? I was under the impression these went right on.
I can’t get the ls1 rotor over the new moser axles. Measuring the bolt pattern on the axle it comes up 4.75” center to center of the stud. The ls1...
My biggest worry with the powder was having to grind the ends back down in order to weld the subframe connectors in then touching it up. I bought...
That’s what doesn’t make sense. The studs I bought show to be .472 those studs show to be .475 but the holes in my axles will eat the .472. I...
