Separate names with a comma.
I am curious if 70-81 Camaro hoods have a part number somewhere on them that can be seen. I think mine is off of a 73 but how can you tell?
I am running into a hurdle trying to fabricate a patch on my 72 Camaro at the upper left corner window channel of the quarter panel and roof where...
I recently replaced the quarter panels, wheelhouses, cross rail, outer rockers, and tail panel on my 72 Camaro. I left both doors and trunk side...
Anyone ever use their front sub-frame (removed) as an engine test stand? I have the sub-frame out of my 72 Camaro while I am doing metal work on...
When welding the cross rail extension to the trunk drop off does the extension get sandwiched in between the quarter panel and the drop off?
What is the best way to go here, stitch or plug weld the patch panel into place? The area needing replaced is forward of the drivers seat just...
Recently I installed a new RH side AMD quarter panel to my 72 Camaro. To remove the old quarter I used a propane torch to get the lead out where...
what is the best technique, strategy to remove rubberized undercoating, nor concerned about mess
I am in need of this ducting for my 72 Camaro. I only need the outer part (pn 8796843), my vent is ok. This part is located in the upper left...
I am in need of a voltage regulator for my 72 Camaro the pn is 1119515 in decent condition pls
I am in need of the vaccum modulater metal line that goes from trans mod to a port at rear top of intake for TH350 trans. I dont want a repro bc...
Does anyone make a replacement or something close for the inner plastic rails located underneath the top of deluxe door panels. These are the ones...
If anyone has ever removed a deck lid hinge and pin from its strap on a 70-81 Camaro? I already have the torque rods out, and deck lid off. The...
Looking for a half decent fixable used LH fender for my 72 Camaro. Its ok if the fender needs some metal work since I have a mig welder. I wish I...
While trial fitting my new RH AMD quarter panel everything seems to line up great (body lines at upper/lower door to qtr, gap between door and...
Needing only the drivers side upholstery (standard) in black if anyone has one to sell.
I have a question about the EDP finish on AMD panels when it comes to spot-welding. I am getting ready to install the outer wheelhouse, trunk drop...
Does it make a difference whether I weld the repair washers to the top of the existing sub-frame mounting brackets which would cause the washers...
I am in need of a patch for the inner wheelhouse on my 72 Camaro from a point halfway down to the bottom edge if you have a 70-81 Camaro that is...
this is the small oval shaped hose that goes on the end of the bottom outlet on the htr box and to a vent tube under the radio. I have looked all...
