Separate names with a comma.
If If you don't do a lot of extended highway driving at higher speeds, go with the 342. If a lot of 70 mile per hour highway runs are in your...
I did the exact same combo on my 68 Chevelle. I originally ran with factory master cylinder in booster But braking performance was terrible. I...
Making good progress i almost bought a red/orange car with black interior over the summer but I really wanted a 4 spd.
My 81 Z has a large vertical dent/crease that the body shop says is cost prohibitve to repair. Looking for a GM skin.
No first gen cars.
I found this place a few weeks ago and wanted to pass along. I bought various parts for my '81 Z28 (console, shifter, door, header panel, bumper...
A member out here posted somewhere that the PTFB guy said 18 x 9.5s with 5.25 BS will fit the front and long as you run the PTFB sway bar and...
I ended up ordering a Jegs 6qt pan made in the USA. It will be a while before I get the engine in the car, so no feedback other than it looks...
The block is a 1972 two piece rms. Thanks though.
Building a 383 for my '81 and found this old thread from 2009: https://nastyz28.com/threads/sbc-355ci-oil-pan-suggestions.179005/ Car will be...
Looking for a rust free driver side door for my 81Z. I'd prefer a door with the crash brace that the 81 came with. My current door has a large...
That's helpful, thanks. Did you have to roll your rear fender lips?
I want to run 18 x 9.5s on the front and rear of my '81 with 275/40s. I've scrolled through hundreds of posts and I have seen some mock ups with...
No clip.
Hey guys, looks like to me the nut should just come off but it will not. Guessing too much rust on the threaded portion. Before I destroy...
Thanks for the input, guys. I went with Sherman. Passenger side includes toe box and goes all the way back under the rear seat (one piece)....
My '81 needs floor pan work and I have a body shop lined up to do the work. Passenger side needs to be replaced from toe board to rear foot well....
I agree with Lowend about the vacuum. I would torque the intake manifold using correct sequence and torque. Check for vacuum leaks all over the...
Where are the new MSD boxes made vs the old boxes?
My brother had a '79 that he picked up in 1985. It was 100% stock with 65K miles, all emissions, stock exhaust. Car was a 350, auto, 3.42 gears,...
