Search results

  1. marks73

    73 quarter panel help!

    originally it was, but resprayed years ago. it was to be Lt Copper, but this color is much lighter than original.
  2. marks73

    73 quarter panel help!

    sure if you can share the shop in Orange it would probably be worth going further for a shop that has had experience with this, Thanks
  3. marks73

    Windshield replacement cost

    I used Safelite, glass is fine but it leaks like crazy, too bad... they just use a ton of silicone, I see you in Reseda, i'm just around the corner in Encino.
  4. marks73

    73 quarter panel help!

    yes, I believe so- so maybe the best was is to to use some por 15 inside the quarter panel and then maybe outside and have a plate welded on it? thanks, great looking 70 you have
  5. marks73

    73 quarter panel help!

    so spot welded from the factory? how did they fill the gap? thanks
  6. marks73

    73 quarter panel help!

    so yes it is assembled, I was going to take the hood, fenders, doors and deck lid off, to get media blasted, and then sand or chemical strip the roof and quarter panels. They will epoxy prime after blasting. I figure this would be the fastest and most complete way of proceeding? welcome your...
  7. marks73

    73 quarter panel help!

    here is a couple of pic 's after sanding. Looks like 1/2 deep but surrounding metal look ok as there is some pitting. definitely some bondo build up by the drip rail. I suppose as hd_cat suggested, I could fill this with a cap. I believe the factory used solder for the original mend? not...
  8. marks73

    73 quarter panel help!

    Thanks everyone... I'll start grinding, sanding and maybe blasting. There is a build up of filler, but everything else looks real smooth. I am starting to see numerous small 1/8 " bubbles starting to appear on the roof, so I have to assume they did not do a great job with the preparation...
  9. marks73

    73 quarter panel help!

    the prior owner had replaced the quarter panel and it was always bubbling and finally took it off and here is the mess I have. I know these are usually soldered, but I think it was just bondo. I think I need to sand to bare metal, but what is the best way to fix this?
  10. Z28

    Z28

  11. 73 Z28 possible repaint

    73 Z28 possible repaint

  12. marks73

    73 Exploding seat belts- solutions

    Thanks, I did see them. I hate to spend $360, but I guess better that to think the worse.
  13. marks73

    73 Exploding seat belts- solutions

    I know there has been a lot of discussion on this, but with the final seat busted, (I have been using aftermarket 2 point) nut with my 8 year old, I need to have the 3 point sealt belt. Any solutions, I can not even find after market 3 point for the 73. Thanks Mark. 73 Z28




Latest posts

Top