4 - Speed hump location

[mallard]

Well then he's trying to balance out the numbers of 4spds vs auto's. He's forgiven.

 

[cisco 1]

Hi
I want to switch my 73 Z28 over to a 4 - speed, Can someone provide me with measurements of where to locate the 4-speed hump in its proper position, and also is the tunnel completely cut out under the hump.
Thank You.

 

[cisco 1]

It from my 73 z-28 LT . The tunnel is very badly crimp from factory . It not been hit it was just crim like that . There a litle pièce off floar to long on the driver side about one inch. The rest off it is cut flush

 

[cisco 1]

 

[cisco 1]

1 7/8 and 2 1/4 inch and were it going out a bit about 1 inch driver side back part

 

[camarozbest]

1 7/8 and 2 1/4 inch and were it going out a bit about 1 inch driver side back part

I just wanted to thank everyone for all the information that they shared and I apologize for get back with the Thank You so late.