79 Z/28: Project Tigger

Discussion in 'Project Progress' started by crazygreek89, Aug 10, 2010.

  1. crazygreek89

    crazygreek89 Member

    Messages:
    60
    Likes Received:
    0
    Joined:
    Aug 6, 2010
    Location:
    Philadelphia, PA
    *UPDATE*

    1) Just won a re-dyed original dash pad on eBay for $190. It's going to be added to my bullet mirror kit and the auto center console kit I have. Ordered some screws from FbodyWarehouse.com to assist in the install of the center console and the dash install as well as the door panels. I have a couple more interior pieces to order such as door panels, carpet and new dash bezel and gauges.

    2) Car is in the shop getting tuned up, oil changed, tranny leak fixed, 2k stall installed, stainless steel brake lines installed and some other minor stuff taken care of.

    Here is a video I took of the beast before it went to the shop last week: http://www.youtube.com/watch?v=WLyPqW7BL1U

    Here is one when I dropped it off in the shop: http://www.youtube.com/watch?v=jEKumnSnANs

    Here's an interior video plus the Pioneer stereo that hasn't been used since 2003! http://www.youtube.com/watch?v=QVqT61XZwIc

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
    Last edited: Aug 21, 2010
  2. crazygreek89

    crazygreek89 Member

    Messages:
    60
    Likes Received:
    0
    Joined:
    Aug 6, 2010
    Location:
    Philadelphia, PA
    UPDATE:

    Car is still in the shop. Tranny was pulled out to get rehabbed and should be going back in today. 2K stall will also be getting installed. Stainless steel brake lines from front to rear installed. Braided stainless steel from front to rear as well. New parking brake cable. New bigger air filter. New plugs. Tuned carb. Remounted trans cooler. Installed B&M console Megashifter.

    More updates to come...
     

Share This Page