Separate names with a comma.
Discussion in 'Project Progress' started by Bob Lane, Jul 15, 2018.
Any photos or measurements of how the new dashboard will compare to the old dashboard?
I am still working on the chassis. i am mocking up the rear suspension now. once that is all set i will be able to set the shell on the frame and remove all the supports that are holding the body together. right now i can't set the dash stuff in place cause the body supports are in the way.
I am looking at a 2016 Camaro complete rear setup now. Any reason you went with the Corvette instead of the Camaro?
I have a Corvette front suspension. I am using the rear out of the 2016 Camaro. just not using the bolt in subframe, it will be mounted to the frame itself. I just started mocking it up this weekend.
wow.... this thing is amazing! looking fwd to seeing this thread continue
broahnazki, Here is the link to my build thread so you can see the entire thing.
Well it’s been awhile but I’m back up and working on the Z again. I have the interior out, front end and chassis clip off and headed to the sandblaster. I hope to put it on the rotisserie within a week. Feels good to turn a few wrench’s.