Dyno tuned 434 SBC 11:1 AFR 245 Solid Roller

[dickeymoore]

Dammit Boy!!!!

 

[ChopperScott]

Locked and loaded…

 

[biker]

You are serious about this! Looking good.

 

[cadillac_al]

Thanks for sharing this build. I would love to see it run. I can't wait to hear your results.

 

[ChopperScott]

Change of plan. Atco was rained out and cancelled yesterday. Last minute scramble brought us to Lebanon Valley Dragway for test and tune. The Camaro ran a best of 1.43 / [email protected] / [email protected] DA was 1396.

This run was 1.43 / [email protected] / [email protected] I was a little slow on reaction time. Trying to shake the rust off after a few years. I still need to dial in the suspension to eliminate wheel slip out of the hole...

 

[biker]

That whole package works nicely. You seem to have the experience to dial it in even more. Well done, sounds great.

 

[muscl car]

Change of plan. Atco was rained out and cancelled yesterday. Last minute scramble brought us to Lebanon Valley Dragway for test and tune. The Camaro ran a best of 1.43 / [email protected] / [email protected] DA was 1396.

This run was 1.43 / [email protected] / [email protected] I was a little slow on reaction time. Trying to shake the rust off after a few years. I still need to dial in the suspension to eliminate wheel slip out of the hole...

Nice pass !!!

What rpm you leaving on the launch with the Transbrake ??

 

[ChopperScott]

What rpm you leaving on the launch with the Transbrake ??

I've got it set at 5500.

I'm heading down to Atco for competition tomorrow with NETO at the Yesteryear Drags. Track prep should be much better. I'll lower air pressure in the rear tires a few psi and see what happens.

 

[1980RS]

I watched your videos today with your car. Looks pretty good out there. Put an electric water pump on it or a 30% underdrive crank pulley on there and pick up some free ET. My 50% underdrive pulley was worth 2 tenths at one race.

 

[ChopperScott]

I've contemplated going to electric water pump. Wiring is already set up for it. I'm currently running a Weiand Team G pump with performance ratio pulleys.