Lower control arm spacers

Discussion in 'Original Drivetrain Topic' started by 70 LT1, May 1, 2006.

  1. 70 LT1

    70 LT1 Member

    Messages:
    92
    Likes Received:
    0
    Joined:
    Jan 3, 2002
    Location:
    Dallas, TX
    I am needing the correct thickness for the 70 Z28 aluminum spacers. I thought I had seen a thread on this a while back but could not find in searching. I know the 70 was a 1 year only and thicker and 71 to ?? was slightly thinner. Would like to know correct dimensions for 70 and 71. Also was the 70 rubber bump stop with the centered hump for that year only or was it also used in 71+? They changed to a later style that was off centered on the hump but when?

    John
     
  2. al8apex

    al8apex Veteran Member

    Messages:
    3,918
    Likes Received:
    5
    Joined:
    Mar 11, 2005
    Location:
    scottsdale, az
    70-74 same, 77-81 same, yet thinner

    It WAS discussed

    I have another set avail on ebay in a week
     
  3. 70 LT1

    70 LT1 Member

    Messages:
    92
    Likes Received:
    0
    Joined:
    Jan 3, 2002
    Location:
    Dallas, TX
    Jim, which ones do you have earlier or later?

    John
     
  4. qxwe

    qxwe Member

    Messages:
    46
    Likes Received:
    0
    Joined:
    Mar 11, 2003
    This has been discussed several times.
     
  5. al8apex

    al8apex Veteran Member

    Messages:
    3,918
    Likes Received:
    5
    Joined:
    Mar 11, 2005
    Location:
    scottsdale, az
    later
     

Share This Page