parts in Milwaukee

[ErikNORCAL]

Not getting around to these anytime soon, looking to free up space by moving the big boxes.. Pick up only at this time - Milwaukee

LS conversion Dynatech long tube headers. ceramic coated, new in the box. $400.

Edelbrock full exhaust system. 2.5" pipes. I know the muffler back tail section is stainless. Need to check if the muffler cases and rest of the system is stainless. x-pipe, edelbrock mufflers, high quality hardware, complete and in the box. $400.

PM me here to get contact info.

thanks, Erik

 

[RICARDO1969]

If it were 3"exhaust i would be all over it.

 

[ErikNORCAL]

I forget what the approx horsepower level was where 3" exhaust would be 'needed' for a street car but seem to recall 600. A well built, free flowing system is the first priority.anyway, I ran 2.5 and smaller diameter header primaries on a well built 454 and didn't think I was leaving anything on the table.

For the dynatech headers, I'm sure people have read these hang low. My car is on eibach front springs which dumps it way more than advertised. I planned to run these as the current gen 1 motor and hooker super comps only gave me trouble on speed bumps. For a stock or near stock height car, I wouldn't even sweat it. Forgot I had 1" set back plates which I will include.