Separate names with a comma.
Discussion in 'Project Progress' started by JumpMaster82d, Oct 27, 2018.
Looking good!! Thanks for the pics. Also I like that tank setup.
were in nc you live i see the profile pic of the 82nd here at bragg im at fort bragg wondering if you in the area never seen your car if ya is????
I got out back in 2009, I currently live near Greensboro NC.
All the new inner rear sheetmetal in place
Quarters and tail panel on
Door panel with Nova arm pads that Ricks Camaro sent...
Before starting on the subframe, you can also see the smooth sheet metal that was cut out and sectioned in for the firewall
Getting there (don't worry, ran out of time and wasn't able to get the last inner frame rail)
An overall of where its at now
Very nice progress and great work on all that sheet metal installation!
Awesome work is my first comment.
I didn’t see any indication of the doors and boot going on for the rear quarter panel alignments, did you put these on or do you have another trick for getting it all lined up
Thanks for the kind words guys! The process has been slow but I've been chipping away when I get free time between the work and family.
Steve, the doors were on when we welded the quarters on however we took them back off afterwards to seam seal and slick sand.
Here's the car back in my shop getting worked on with the doors.
New (to me) upper and lower control arms after scuffing up and throwing some fresh paint on
New IROC steering box
And after 2 months, my bolt on VFN Sunoco hood finally arrived
Very nice! I like that hood too!
Nice firewall, how are you going to go about plumbing in a heater box and demister
Been chipping away at it over the last two months. Should be ready for paint by the end of the month!