UMI's Newest Test Vehicle- 1971 Camaro, Pro-touring Project

Hello,

Unfortunately not, it will require cutting and welding. We are bolting it into the stock a-arm mounts to make installation and positioning easier. Thanks for looking!

 

Our new Bowler Performance Tremec 6-speed is in along with the Quicktime bellhousing. We have it mounted to a mock up LS block and setting in the subframe to determine the driveline angle and also motor location. We have the minitub kit installed and now welding the frame rails in while starting the cage.

 

Thanks guys. It is a fun project for sure. It if was our only project it would be going a lot quicker... but we have a few other cars in the works while trying to design products.

 

Our American Racing LSX headers for the 70-81 came in and they look nice! We sat a set of factory heads on the block and started mocking up engine location. Our Holley oil pan also came in so this allows us to place the engine where we want it now. Now that the engine is located we begin to build LS engine mounts and a T56 crossmember.

While we are doing that we also started bending up the cage for the car.

 

A few more updates. The guys started setting the cage in place and it is looking good. The Boyd Welding fuel tank came in and looks really nice, this should work perfect for us. Nate also finished the transmission crossmember.