WallyHawk
New Member
- Jul 18, 2021
- 23
I just got done installing the full 20114 direct replacement painless harness. Testing stuff on the car I have 3 issues to clear up and am good to go. The one I'm most confused on is the heater.
Car originally had AC from the factory. I'm missing some stuff from the engine bay but still have most of it. I don't care if this stuff sits there. I just want the defogger working. I spliced the painless connector for the resistor to fit the 4 pin resistor. Someone from painless helped me through which wire went where.
When testing the car nothing happens. Fan doesn't even seem to kick on. I double checked connections and grounds and everything seems solid.
Searching found a bunch of subjects on this but most were very old and only a couple replies that didn't clear things up for me.
Thanks in advance.
Car originally had AC from the factory. I'm missing some stuff from the engine bay but still have most of it. I don't care if this stuff sits there. I just want the defogger working. I spliced the painless connector for the resistor to fit the 4 pin resistor. Someone from painless helped me through which wire went where.
When testing the car nothing happens. Fan doesn't even seem to kick on. I double checked connections and grounds and everything seems solid.
Searching found a bunch of subjects on this but most were very old and only a couple replies that didn't clear things up for me.
Thanks in advance.
