Someone wanna dyno this for me?

[CamaroMan79]

Anyone have a dyno program?

383

Block: 350
bore: 4.030
stroke: 3.75
Rod length: 5.7
Heads: Edelbrock performer RPMS(Int/Ex, .100"-.600")
67/58 130/108 183/144 226/169 229/175 232/182
Compression: 9.9
Carb: 770 w/ vaccum secondaries
Intake: RPM Air Gap (Dual Plane) w/ 1" carb spacer
Headers: 1 3/4" mufflers, and electric cutouts
Cam: Crower Hydraulic flat tappet (234/244@.050, .498"/.513" lift, 110 lobe, 106 centerline,
Rocker arms: Comp Cams Pro magnum 1.52 ratio
Ignition: Mallory Billet HEI

 

[Dyno_Ron]

If it wasn't so late here I would type in the flow numbers, I ran using port dimensions instead - still should be pretty close.

 

[Cardinal]

Are the power numbers at the flywheel or at the wheels?

 

[Dyno_Ron]

Are the power numbers at the flywheel or at the wheels?

Its set at STP flywheel numbers. You can also set it for the SAE output

 

[Lowend]

Run the 64cc heads with flattop pistons , it will bump the compression up to more like 10.6-1 and the engine will be putting out more in the low-mid 400HP range

 

[CamaroMan79]

I downloaded the virtual engine dyno and these are the numbers I came up with